Detection Systems DS7400Xi Guide de l'utilisateur télécharger pdf (Page 19)

- 19 -

This chart will guide you through the steps necessary to Change the Expiration Date for Temporary PINs.

You should write down your entries before you enter the Master Code Programming Mode

and have them with you as you begin programming. Make your entries promptly.

If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone occurs and exits you from the

programming mode.

Note: Entering the command sequence [Master Code] [#] [0] [3] [#] will cause the DS7447/DS7447E keypad to read

back the temporary code expiration date.

Changing the Expiration Date (for Temporary PINs)

It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a

DS7445/DS7445i keypad.

Steps to Change the Date Command Sequence If Accepted, DS7447/DS7447E Display

Reads

#1.

Enter the Master Code

Programming Mode.

[Master Code] + [#] [0] “2 Change Date”

(display will scroll to this)

#2.

Enter a 3. [3] “Enter Month”

(01 … 12)

#3.

Enter the expiration

Month.

[0] [1] through [1] [2]

January December

“Enter Day”

(01 … 31)

#4.

Enter the expiration

Day.

The temporary PIN will

expire at Midnight on

the day selected.

[0] [1] through [3] [1] “Enter Year”

(XX) End with #

#5.

Enter the Year. The last two digitis of

the year followed by

the [#] key.

“Month, Day, Year”

A long beep signifies acceptance.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Pas de commentaire

Detection Systems DS7400Xi Guide de l'utilisateur Page 19