Detection Systems DS7400Xi Guide de l'utilisateur télécharger pdf (Page 10)

- 10 -

This chart explains the procedure for Force Arming your

system if one or more zones are faulted.

When one or more zones are faulted, the system may be Force

Armed (if programmed) by bypassing the faulted zones. The

DS7447/DS7447E display will read “Not Ready” and the

DS7445/DS7445i's zone LEDs (1-8) will be on when Force Arming

is required to arm the system.

Force Arming during an AC power failure: Regular arming

of the control panel is not permitted during an AC power failure.

Having to Force Arm serves as a warning that the control panel

is operating under backup battery.

WARNING

Bypassing or Force Arming removes some of your building’s

protection because it excludes the faulted zones from arming.

Therefore, an intrusion may not be detected or the detection

may be delayed. Always attempt to correct any zone problems

(close doors and windows, etc.) before using these features. If

the problem can not be corrected, contact your installing

company.

Note: See Zone Bypass for an alternate method of arming

the system when faults exist. Force arming is not

available in U.L. Listed systems.

Force Arming your System

What to DoType of Arming What to Do What will HappenWhat will Happen

Force

Arming

Enter any

arming command

Press

[Bypass]

during the 5

second beep.

Exit during the

exit delay

interval if

leaving.

A five second beep occurs,

indicating the control panel

has faulted zones and needs

to be Force Armed, or a

three-beep error tone occurs

indicating Force Arming has

not been accepted or allowed.

The red Armed Light will flash

during the exit delay.

The control panel will arm with the

faulted zones bypassed, or a

three-beep error tone occurs

indicating Force Arming has not

been accepted or allowed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Detection Systems DS7400Xi Guide de l'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Detection Systems DS7400Xi