Detection Systems DS7400Xi Guide de l'utilisateur télécharger pdf (Page 24)

- 24 -

Fire Reset

During a fire alarm, exit the premises immediately. When you

have determined there is no fire, you must silence the bells/

sirens before you can initiate the System Reset command.

[PIN] + [System Reset]

Before the System Reset command is used, determine

which smoke detector has alarmed so the monitoring

company may verify its operation.

A [PIN] followed by the [System Reset] key will reset any smoke

detectors after a fire alarm has occurred.

Note: To use the System Reset command sequence, your

PIN must have disarm privileges.

The System Reset command will perform a fire reset, a battery

test and will clear all system troubles.

Fire Trouble

A Fire Trouble message with a zone number signifies a problem

with the fire system, such as a break in the wiring that monitors

smoke detectors. A Fire Trouble message with no zone number

indicates a ground fault if the unit is in the Commercial Fire Mode.

A Fire Trouble will be indicated by a short beep from the keypad

sounders every 10 seconds. The DS7447/DS7447E will display

“Fire Trouble” followed by the zones in a trouble condition. The

DS7445/DS7445i will turn the Fire and Trouble Lights on steady

and will light the corresponding zone LEDs.

Notify your installing company immediately if the Fire Trouble

message is displayed.

The Fire Trouble beep can be silenced with any [PIN] followed

by the [Off] key. After problems have been remedied, a [PIN]

followed by the [Off] key should again be entered to clear the

“Fire Trouble” display.

Fire Reset / Fire Trouble

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Pas de commentaire

Detection Systems DS7400Xi Guide de l'utilisateur Page 24