- 20 -
This chart will guide you through the steps necessary to change the Time displayed at the keypads.
You should write down your entries before you enter the Master Code Programming Mode
and have them with you as you begin programming. Make your entries promptly.
If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone occurs and exits you from the
programming mode.
Note: Entering the command sequence [Master Code] [#] [0] [6] [#] will cause the DS7447/DS7447E keypad to display the
time.
Changing the Time
It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a
DS7445/DS7445i keypad.
Steps to Change the Date Command Sequence If Accepted, DS7447/DS7447E Display
Reads
#1.
Enter the Master Code
Programming Mode.
[Master Code] + [#] [0] “2 Change Date”
(display will scroll to this)
#2.
Enter a 6. [6] “Enter Month”
(01 … 12)
#3.
Enter the Day. [1] through [7]
Sunday Saturday
“Enter Time”
(0100 … 1259)
#4.
Enter the Time.
(Hour and minute)
[0] [1] [0] [0] through
[1] [2] [5] [9]
“Enter AM\PM”
(4/6) End with #
#5.
Enter AM or PM. [4] [#] or [6] [#]
(4 = AM, 6 = PM)
“Day - Time”
A long beep signifies acceptance.
Commentaires sur ces manuels